APC

APC Back-UPS Pro 1000VA / 600W (BR1000MS)

The official replacement cartridge for the BR1000MS is APCRBC160. Schneider’s official cartridge page describes it as a 12 V, 7.2 Ah lead-acid pack with a 2-year repair-or-replace warranty. Do not use the older BR1000G cartridge (APCRBC123) in this unit.

Official replacement cartridge

APCRBC160

Official SKUAPCRBC160
Voltage12 V (official APCRBC160 product page and family user manual; see the voltage note below)
Capacity7.2 Ah (official APCRBC160 product page; the BR1000MS datasheet lists 7.0 Ah — see the note below)
TypeLeak-proof sealed lead-acid, fully assembled
Cartridge quantity1
Cartridge warranty2-year repair or replace (official APCRBC160 product page)

Official APCRBC160 product page

UPS specifications (from the official datasheet or product page)

Family / product nameAPC Back-UPS Pro 1000VA / 600W (BR1000MS)
VA rating1000 VA
Watt rating600 W
TopologyLine interactive
WaveformSine wave
Input voltage120 V AC, 1 phase
Form factorTower (not rack-mountable)
Outlets10 × NEMA 5-15R (6 battery + surge, 4 surge-only), plus USB Type A + Type C charging ports
Transfer time8 ms typical, 10 ms maximum
Typical recharge time16 hours (typical)
Typical battery life3–5 years
Official RBC quantity1
User-replaceable batteryYes (official product page, datasheet, and USA/Canada table)
UPS warranty (as published)36 months (UPS), 12 months (battery supplied with the UPS). The family user manual also states a standard three-year warranty from the date of purchase.
Equipment protection policyLifetime: $250,000

Related models

How to replace the battery

Schneider publishes an installation guide covering APCRBC160, APCRBC161, APCRBC162, and APCRBC163, and a Back-UPS Pro user manual that includes the BR1000MS. Follow those official sheets. The family manual tells you to use only a genuine APC RBC and to replace batteries with the same number and type originally installed.

Official installation video: https://www.se.com/us/en/download/document/SPD_AHUG-AS869H_EN/

  1. Confirm the rear or bottom label says BR1000MS, not BR1000G. The official cartridge for this model is APCRBC160, not APCRBC123.
  2. Read the official APCRBC160 / 161 / 162 / 163 installation guide and the instruction sheet packed with the cartridge.
  3. The family user manual says to power the UPS off, unplug it from AC input, and disconnect the batteries if you are replacing a leaking or over-temperature pack, and not to operate the UPS until the batteries have been replaced.
  4. Install the complete official APCRBC160 cartridge as a unit. Recycle the used pack (the official cartridge page notes support for APC-authorized recycling).
  5. Allow the official typical 16-hour recharge before judging runtime.

These are orientation steps, not a substitute for the manufacturer’s instruction sheet. Lead-acid UPS batteries can present electrical and chemical hazards.

Warranty considerations

Genuine vs third-party packs. This guide lists only the official manufacturer cartridge. Third-party kits are widely sold, but this site does not verify their dimensions, runtime, or safety against the OEM specification. Schneider Electric’s FAQ on genuine APC RBCs states that a non-APC battery may result in lower runtime, damage the UPS, create hazardous conditions, or void safety certifications, and that it will void APC’s Equipment Protection Policy. If you still consider an aftermarket pack, treat voltage, capacity, and physical fit as necessary starting points — not as proof of compatibility — and expect warranty terms to change.

When to replace the whole UPS instead

Where to buy (affiliate placeholders)

These are ordinary search links, not tracked affiliate tags. When a program is joined, replace the href and keep the data-affiliate attribute.

Search Amazon for APC APCRBC160 Affiliate placeholderSearch eBay for APC APCRBC160 Affiliate placeholder

Affiliate disclosure

FAQ

What battery does a BR1000MS take?

Official sources agree on the SKU: the current BR1000MS datasheet, the official product page, the USA/Canada Back-UPS table, and the Back-UPS Pro user manual all list APCRBC160.

Can I use the APCRBC123 from a BR1000G?

No. Official documentation assigns APCRBC123 to the discontinued BR1000G and APCRBC160 to the BR1000MS. They are different official cartridges.

Why do some official pages say 12 V and another says 24 V?

The official APCRBC160 product page describes a 12 V, 7.2 Ah cartridge, and the family user manual lists APCRBC160 as lead-acid, 12 Vdc, 1 module. The current official BR1000MS datasheet lists a UPS battery voltage of 24 V and a battery capacity of 7.0 Ah, while still naming APCRBC160 as the replacement. This guide does not resolve that discrepancy. Order the official SKU APCRBC160 and confirm the cartridge label.

Sources